LUMI LIGHT INSTRUCTIONS

Turn On

Double Tap or Hold (1 Sec)

Check Battery

Tap when off

Green=70%+ Yellow=30%+ Red=30%-

Next Mode

Tap

Previous Mode

Double Tap

Turn Off

Hold

Brightness Control

Four taps (from off)

Cycle through the four brightness levels. The default level is Level 3. Max is Level 4.
Single Click to cycle,
Long Press to save.

Start-up Mode

Five Taps (from off)

Choose between starting from your last used mode or resetting to the first mode upon power-up.
Green Flash = Start on Last Used
Orange Flash = Start from Mode 1

Flow Mode

Six taps (from off)

Toggle between Juggle (Slower) and Spin (Faster) mode groups to instantly change the speed and style of your light patterns.
Pink Flash = Juggle Mode
Blue Flash = Spin Modes.

24 ADVANCED COLOUR MODES

METEORS - STROBES - RAINBOWS - SOLIDS

SPIN - Fast Mode

Optimized for high-speed movement. This mode ensures patterns remain crisp and vibrant during fast spins and rapid transitions.

JUGGLE - Slow Mode

Optimized for technical, rhythmic movement. This mode enhances pattern detail and trail visibility when the prop is moving at a slower, controlled pace.

Charging Cable / Power Warning!

Charging Cable included. Power adapter not included. Use only a standard USB power adapter: 5V, up to 2A (10W max). Regular phone chargers (5V 1A or 2A) are safe. Do not use fast-charge or high-voltage adapters (9V, 12V, 20V) - this may overheat the cable, damage the poi, or cause a fire hazard.

CHARGING THE LIGHTS

1- Remove the Fabric Cover: Unzip the cover and slide it off. 

 2- Use the provided USB-C cable to plug the lights in for charging.

 3- Optional: If you need to charge the lights outside the fan, you can remove the light unit lifting them out with your fingernail or a small flat-head screwdriver.

 

 COLLAPSING THE LUMI FAN

1-Remove the Fabric Cover: Unzip the cover and slide it off. 

2- Collapse the Frame: Hold the end of a spoke and with your other hand pull the connecting arch section outward to disconnect it. Repeat this step for all spoke ends. 

3- Removing the Spokes: Firmly hold the Handle and pull/twist one spoke out of the handle. This connection should feel tight and secure. If the connection feels too tight or too loose, proceed to the Adjusting the Spoke Connection section below.

 

 ADJUSTING THE SPOKE CONNECTION

 1- Access the Connector: Remove all spokes from the handle to expose the handle connector ends.

2- Adjust the Screw: Use a Phillips head screwdriver to adjust the connection screw:

To make the spoke connection tighter, turn the screw clockwise (to tighten it).

 To make the spoke connection looser, turn the screw counter-clockwise (to loosen it). Adjust the screw incrementally until you find the desired tension.

 3-Reattach the spokes. You're all set!