LUMI LIGHT INSTRUCTIONS

Turn On

Double Tap or Hold (1 Sec)

Check Battery

Tap when off

Green=70%+ Yellow=30%+ Red=30%-

Next Mode

Tap

Previous Mode

Double Tap

Turn Off

Hold

Brightness Control

Four taps (from off)

Cycle through the four brightness levels. The default level is Level 3. Max is Level 4.
Single Click to cycle,
Long Press to save.

Start-up Mode

Five Taps (from off)

Choose between starting from your last used mode or resetting to the first mode upon power-up.
Green Flash = Start on Last Used
Orange Flash = Start from Mode 1

Flow Mode

Six taps (from off)

Toggle between Juggle (Slower) and Spin (Faster) mode groups to instantly change the speed and style of your light patterns.
Pink Flash = Juggle Mode
Blue Flash = Spin Modes.

24 ADVANCED COLOUR MODES

METEORS - STROBES - RAINBOWS - SOLIDS

SPIN - Fast Mode

Optimized for high-speed movement. This mode ensures patterns remain crisp and vibrant during fast spins and rapid transitions.

JUGGLE - Slow Mode

Optimized for technical, rhythmic movement. This mode enhances pattern detail and trail visibility when the prop is moving at a slower, controlled pace.

Charging Cable / Power Warning!

Charging Cable included. Power adapter not included. Use only a standard USB power adapter: 5V, up to 2A (10W max). Regular phone chargers (5V 1A or 2A) are safe. Do not use fast-charge or high-voltage adapters (9V, 12V, 20V) - this may overheat the cable, damage the poi, or cause a fire hazard.

 EASY INSTALLATION GUIDE

  1. Tape the rope: Wrap sticky tape tightly around the rope at your desired length.

  2. Cut: Use a Stanley knife or scissors to cut through the middle of the taped section.

  3. Thread the knob: Slide the silicone knob onto the rope.

  4. Thread the ring: Slide the 3D-printed ring onto the rope. (If using a 6mm rope, insert the included metallic washer after the ring.)

  5. Melt the stopper: Carefully melt the rope end to create a secure stopper. While warm, flatten it against a metal surface to form a wide "mushroom" shape. Ensure it fits snugly inside the plastic ring without being too wide to slide in.

  6. Attach the light: Insert the light unit into the plastic ring and secure it with the provided screw.

  7. Finish: Slide the silicone handle over the light unit until fully seated.

You're ready to glow!